Rki-instruments 1017-04 Bedienungsanleitung

www.rkiinstruments.com Model 1017-04 Combustible Gas SampleDraw Detector HeadOperator’s ManualPart Number: 71-0274RKRevision: AReleased: 5/22/1

6 • Model 1017-04 Operator’s ManualCAUTION: Do not route controller power and detector wiring through the same conduit hub. The power cable may disru

Model 1017-04 Operator’s Manual • 7Start UpThis section describes procedures to start up the Model 1017-04 and place it into normal operation.Introd

8 • Model 1017-04 Operator’s ManualMaintenanceThis section describes maintenance procedures. It includes preventive maintenance procedures. This sect

Model 1017-04 Operator’s Manual • 9Probable causes• The calibration cylinder is low, out-dated, or defective.• The Model 1017-04’s flow rate is too

10 • Model 1017-04 Operator’s ManualNOTE: Make sure the bottom ferrule is laying flat in the nut.4. Insert the cone-shaped front ferrule on top of th

Model 1017-04 Operator’s Manual • 113. Allow the Model 1017-04 to draw sample for one minute.4. Follow the directions in the controller’s operator’s

Model 1017-04 Operator’s ManualWARNINGRead and understand this instruction manual before operating instrument. Improper use of the gas monitor could

Model 1017-04 Operator’s ManualWarrantyRKI Instruments, Inc. warranties gas alarm equipment manufactured by RKI and sold by RKI to be free from defec

Model 1017-04 Operator’s ManualTable of ContentsOverview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Model 1017-04 Operator’s Manual • 1Sample-Draw Combustible Gas DetectionOverviewThis manual describes the Model 1017-04 sample draw combustible gas

2 • Model 1017-04 Operator’s ManualDescriptionThis section describes the components of the Model 1017-04. The Model 1017-04 consists of the housing a

Model 1017-04 Operator’s Manual • 3Figure 2: Model 1017-04 Flow DiagramSubpanel AssemblyAll the internal components of the Model 1017-04 are part o

4 • Model 1017-04 Operator’s ManualInstallationThis section describes procedures to mount the Model 1017-04 in the monitoring environment and wire it

Model 1017-04 Operator’s Manual • 5Connecting the Sample Lines to the Model 1017-041. Attach 1/4 inch O.D. rigid sample tubing to the INLET fitting.