Rki-instruments SDM-E2 Bedienungsanleitung PDF herunterladen (Seite 22)

17 • Setting the Operational Parameters in Edit Mode

Setting the Bump Test Parameters

Do the following to set the bump test parameters after establishing a connection

between an EAGLE 2 and the SDM-E2.

1. Turn on the SDM-E2 with an EAGLE 2 and establish a connection between

them as described above in "Turning on the SDM-E2 with an EAGLE 2". The

EAGLE 2 will display the home screen.

2. Press and hold the EDIT ENTER button for 2 seconds. The EAGLE 2 will

display the Edit Mode screen.

3. Press and release the BUMP T button. The EAGLE 2 will display the following

screen with the four bump test parameters and their settings.

CH4 50%LEL GAS1

OXY 12.0vol% GAS1

H2S 25.0ppm GAS1

CO 50ppm GAS1

---

EDIT MODE

BUMP TEST : BUMP

CALIBRATION : CAL

GAS INLET : EDIT

BUMP TEST PARAMETER

1.AIR TIME: 30sec

2.GAS TIME: AUTO

3.CHECK : +-50%

4.AUTO CAL: OFF

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 88 89

Keine Kommentare

Rki-instruments SDM-E2 Bedienungsanleitung Seite 22