Rki-instruments GP-01 with self resetting alarms Bedienungsanleitung Seite 1

Model GP-01 Combustible Gas Monitor With Self-Resetting Alarms Operator’s Manual Part Number: 71-0105RKRevision: 0Released: 1/17/05 RKI Instruments,

10 • Description Model GP-01 Operator’s Manualthey turn dark brown. Frequency of replacement depends on how often the Model GP-01 is exposed to H2S a

Model GP-01 Operator’s Manual Description • 11LCDThe LCD is visible through the front of the case. When the GP-01 is in Measuring Mode, the target ga

12 • Description Model GP-01 Operator’s ManualNOTE: The printed circuit boards contain no user serviceable parts.Alarm LightsThe Model GP-01 has two

Model GP-01 Operator’s Manual Start Up • 13Start UpThis section explains how to start up the Model GP-01 and to get it ready for operation.CAUTION: B

14 • Operation Model GP-01 Operator’s ManualTurning Off the Model GP-011. Press and hold the POWER/MODE button for about five seconds to turn off the

Model GP-01 Operator’s Manual Operation • 15NOTE: The peak gas reading is cleared automatically when the Model GP-01 is turned off.1. The unit must b

16 • Operation Model GP-01 Operator’s Manual• The GP-01 provides the combustible sensor with some protection against exposure to high levels of combu

Model GP-01 Operator’s Manual Operation • 17AlarmsThis section covers alarm indications and how to respond to an alarm condition.Alarm IndicationsThe

18 • Operation Model GP-01 Operator’s ManualSelf-resetting Gas AlarmsThe GP-01 has self-resetting alarms. A gas alarm will automatically be reset and

Model GP-01 Operator’s Manual Operation • 193. Calibrate the Model GP-01 as described in the calibration section of this manual.4. If the over range

2 • WarrantyModel GP-01 Operator’s Manual Warranty RKI Instruments, Inc., warrants the Model GP-01 Single LEL Gas Monitor sold by us to be free fro

20 • Alarm Points Model GP-01 Operator’s ManualAlarm PointsThe Model GP-01 allows you to display and set the alarm points. There is a low alarm point

Model GP-01 Operator’s Manual Alarm Points • 21quick succession increases the low alarm point one number at a time. Pressing and holding the AIR butt

22 • Calibration Model GP-01 Operator’s ManualCalibrationThis section covers the calibration of the Model GP-01. Setting the fresh air reading is des

Model GP-01 Operator’s Manual Calibration • 23•You will need a gas cylinder with an appropriate concentration of the target gas. The Model GP-01’s ca

24 • Calibration Model GP-01 Operator’s ManualIf you want to cancel the calibration while in Span Adjustment Mode, press and hold the AIR key for 3 s

Model GP-01 Operator’s Manual Maintenance • 25MaintenanceThis section describes troubleshooting procedures for the Model GP-01. It also describes how

26 • Maintenance Model GP-01 Operator’s ManualReplacing or Charging the BatteriesWARNING: To prevent ignition of a hazardous atmosphere, batteries mu

Model GP-01 Operator’s Manual Maintenance • 27To Replace the Alkaline Batteries or Ni-Cad Battery PackNOTE: The Ni-Cad battery pack will have a typic

28 • Maintenance Model GP-01 Operator’s Manual5. When a full charge has been reached, approximately 40 minutes, the red LED on the charging station w

Model GP-01 Operator’s Manual Maintenance • 293. When a full charge has been reached, approximately 40 minutes, the red LED on the charging station w

Model GP-01 Operator’s Manual Table of Contents • 3 Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

30 • Maintenance Model GP-01 Operator’s Manual4. Carefully remove the old sensor from the sensor socket. NOTE: Note the orientation of the old sensor

Model GP-01 Operator’s Manual Maintenance • 313. Rotate the membrane retainer about one-quarter turn counterclockwise to remove it from the sensor re

32 • Parts List Model GP-01 Operator’s ManualParts ListTable 7 lists replacement parts and accessories for the Model GP-01.Table 7: Parts ListPart Nu

Model GP-01 Operator’s Manual Parts List • 3381-1003RK Regulator, fixed flow, 0.5 LPM, for 17/34 liter steel cylinder81-1004RK Regulator, fixed flow, 0.5

4 • Table of Contents Model GP-01 Operator’s ManualMaintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Model GP-01 Operator’s Manual Introduction • 5IntroductionUsing an advanced microprocessor controlled detection system, the Model GP-01 Single LEL Ga

6 • Specifications Model GP-01 Operator’s ManualSpecificationsTable 1: Model GP-01 SpecificationsTarget Gas Combustible Gas, Methane (CH4) Calibration

Model GP-01 Operator’s Manual Description • 7DescriptionThis section describes the components of the Model GP-01. These components include the GP-01’

8 • Description Model GP-01 Operator’s ManualProtective Rubber BootsA protective rubber boot is installed over each end of the GP-01. The sensor end

Model GP-01 Operator’s Manual Description • 9Alligator and Belt ClipsThe GP-01 is available with two types of clips, the alligator clip and the belt